--- a/arch/arm/boot/dts/qcom-ipq8064.dtsi
+++ b/arch/arm/boot/dts/qcom-ipq8064.dtsi
@@ -352,6 +352,7 @@
 			gpio-ranges = <&qcom_pinmux 0 0 69>;
 			#gpio-cells = <2>;
 			interrupt-controller;
+			#address-cells = <0>;
 			#interrupt-cells = <2>;
 			interrupts = <GIC_SPI 16 IRQ_TYPE_LEVEL_HIGH>;
 
@@ -379,6 +380,7 @@
 					function = "pcie3_rst";
 					drive-strength = <12>;
 					bias-disable;
+					output-low;
 				};
 			};
 
@@ -411,12 +413,9 @@
 			};
 
 			nand_pins: nand_pins {
-				mux {
+				disable {
 					pins = "gpio34", "gpio35", "gpio36",
-					       "gpio37", "gpio38", "gpio39",
-					       "gpio40", "gpio41", "gpio42",
-					       "gpio43", "gpio44", "gpio45",
-					       "gpio46", "gpio47";
+					       "gpio37", "gpio38";
 					function = "nand";
 					drive-strength = <10>;
 					bias-disable;
@@ -424,6 +423,8 @@
 
 				pullups {
 					pins = "gpio39";
+					function = "nand";
+					drive-strength = <10>;
 					bias-pull-up;
 				};
 
@@ -431,6 +432,8 @@
 					pins = "gpio40", "gpio41", "gpio42",
 					       "gpio43", "gpio44", "gpio45",
 					       "gpio46", "gpio47";
+					function = "nand";
+					drive-strength = <10>;
 					bias-bus-hold;
 				};
 			};
@@ -439,6 +442,7 @@
 		intc: interrupt-controller@2000000 {
 			compatible = "qcom,msm-qgic2";
 			interrupt-controller;
+			#address-cells = <0>;
 			#interrupt-cells = <3>;
 			reg = <0x02000000 0x1000>,
 			      <0x02002000 0x1000>;
@@ -468,11 +472,13 @@
 		acc0: clock-controller@2088000 {
 			compatible = "qcom,kpss-acc-v1";
 			reg = <0x02088000 0x1000>, <0x02008000 0x1000>;
+			clock-output-names = "acpu0_aux";
 		};
 
 		acc1: clock-controller@2098000 {
 			compatible = "qcom,kpss-acc-v1";
 			reg = <0x02098000 0x1000>, <0x02008000 0x1000>;
+			clock-output-names = "acpu1_aux";
 		};
 
 		adm_dma: dma-controller@18300000 {
@@ -496,13 +502,13 @@
 		};
 
 		saw0: regulator@2089000 {
-			compatible = "qcom,saw2";
+			compatible = "qcom,saw2", "qcom,apq8064-saw2-v1.1-cpu", "syscon";
 			reg = <0x02089000 0x1000>, <0x02009000 0x1000>;
 			regulator;
 		};
 
 		saw1: regulator@2099000 {
-			compatible = "qcom,saw2";
+			compatible = "qcom,saw2", "qcom,apq8064-saw2-v1.1-cpu", "syscon";
 			reg = <0x02099000 0x1000>, <0x02009000 0x1000>;
 			regulator;
 		};
@@ -530,7 +536,7 @@
 				status = "disabled";
 			};
 
-			i2c@124a0000 {
+			gsbi2_i2c: i2c@124a0000 {
 				compatible = "qcom,i2c-qup-v1.1.1";
 				reg = <0x124a0000 0x1000>;
 				interrupts = <GIC_SPI 196 IRQ_TYPE_LEVEL_HIGH>;
@@ -676,9 +682,6 @@
 			compatible = "qcom,ipq806x-nand";
 			reg = <0x1ac00000 0x800>;
 
-			pinctrl-0 = <&nand_pins>;
-			pinctrl-names = "default";
-
 			clocks = <&gcc EBI2_CLK>,
 				 <&gcc EBI2_AON_CLK>;
 			clock-names = "core", "aon";
@@ -733,10 +736,13 @@
 			tsens_calib_backup: calib_backup@410 {
 				reg = <0x410 0xb>;
 			};
+			speedbin_efuse: speedbin@0c0 {
+				reg = <0x0c0 0x4>;
+			};
 		};
 
 		gcc: clock-controller@900000 {
-			compatible = "qcom,gcc-ipq8064";
+			compatible = "qcom,gcc-ipq8064", "syscon";
 			reg = <0x00900000 0x4000>;
 			#clock-cells = <1>;
 			#reset-cells = <1>;
@@ -768,10 +774,45 @@
 			clocks = <&gcc RPM_MSG_RAM_H_CLK>;
 			clock-names = "ram";
 
+			#address-cells = <1>;
+			#size-cells = <0>;
+
 			rpmcc: clock-controller {
 				compatible = "qcom,rpmcc-ipq806x", "qcom,rpmcc";
 				#clock-cells = <1>;
 			};
+
+			regulators {
+				compatible = "qcom,rpm-smb208-regulators";
+
+				smb208_s1a: s1a {
+					regulator-min-microvolt = <1050000>;
+					regulator-max-microvolt = <1150000>;
+
+					qcom,switch-mode-frequency = <1200000>;
+				};
+
+				smb208_s1b: s1b {
+					regulator-min-microvolt = <1050000>;
+					regulator-max-microvolt = <1150000>;
+
+					qcom,switch-mode-frequency = <1200000>;
+				};
+
+				smb208_s2a: s2a {
+					regulator-min-microvolt = < 800000>;
+					regulator-max-microvolt = <1250000>;
+
+					qcom,switch-mode-frequency = <1200000>;
+				};
+
+				smb208_s2b: s2b {
+					regulator-min-microvolt = < 800000>;
+					regulator-max-microvolt = <1250000>;
+
+					qcom,switch-mode-frequency = <1200000>;
+				};
+			};
 		};
 
 		tcsr: syscon@1a400000 {
@@ -965,7 +1006,7 @@
 
 		gmac0: ethernet@37000000 {
 			device_type = "network";
-			compatible = "qcom,ipq806x-gmac";
+			compatible = "qcom,ipq806x-gmac", "snps,dwmac";
 			reg = <0x37000000 0x200000>;
 			interrupts = <GIC_SPI 220 IRQ_TYPE_LEVEL_HIGH>;
 			interrupt-names = "macirq";
@@ -989,7 +1030,7 @@
 
 		gmac1: ethernet@37200000 {
 			device_type = "network";
-			compatible = "qcom,ipq806x-gmac";
+			compatible = "qcom,ipq806x-gmac", "snps,dwmac";
 			reg = <0x37200000 0x200000>;
 			interrupts = <GIC_SPI 223 IRQ_TYPE_LEVEL_HIGH>;
 			interrupt-names = "macirq";
@@ -1013,7 +1054,7 @@
 
 		gmac2: ethernet@37400000 {
 			device_type = "network";
-			compatible = "qcom,ipq806x-gmac";
+			compatible = "qcom,ipq806x-gmac", "snps,dwmac";
 			reg = <0x37400000 0x200000>;
 			interrupts = <GIC_SPI 226 IRQ_TYPE_LEVEL_HIGH>;
 			interrupt-names = "macirq";
@@ -1037,7 +1078,7 @@
 
 		gmac3: ethernet@37600000 {
 			device_type = "network";
-			compatible = "qcom,ipq806x-gmac";
+			compatible = "qcom,ipq806x-gmac", "snps,dwmac";
 			reg = <0x37600000 0x200000>;
 			interrupts = <GIC_SPI 229 IRQ_TYPE_LEVEL_HIGH>;
 			interrupt-names = "macirq";
@@ -1065,8 +1106,6 @@
 			clocks = <&gcc USB30_0_UTMI_CLK>;
 			clock-names = "ref";
 			#phy-cells = <0>;
-
-			status = "disabled";
 		};
 
 		ss_phy_0: phy@100f8830 {
@@ -1075,8 +1114,6 @@
 			clocks = <&gcc USB30_0_MASTER_CLK>;
 			clock-names = "ref";
 			#phy-cells = <0>;
-
-			status = "disabled";
 		};
 
 		usb3_0: usb3@100f8800 {
@@ -1176,7 +1213,7 @@
 		};
 
 		amba: amba {
-			compatible = "simple-bus";
+			compatible = "arm,amba-bus";
 			#address-cells = <1>;
 			#size-cells = <1>;
 			ranges;
@@ -1195,7 +1232,6 @@
 				non-removable;
 				cap-sd-highspeed;
 				cap-mmc-highspeed;
-				mmc-ddr-1_8v;
 				vmmc-supply = <&vsdcc_fixed>;
 				dmas = <&sdcc1bam 2>, <&sdcc1bam 1>;
 				dma-names = "tx", "rx";